Enable IPMI over Lan using DELL EMC OpenManage System Administrator (OMSA) CLI

IF you try to get IPMI Commands from your Dell DRAC and keep getting the error:

Error: Unable to establish IPMI v2 / RMCP+ session

The the problem is most likely that "IPMI over Lan" is dissabled. You can find out the status of "IPMI over Lan" by using the Dell EMC OpenManage System Administration (OMSA) omreport tool and issuing the following command:

omreport chassis remoteaccess

IF you see the line 

Enable IPMI Over LAN               : No

You can issue the command:

omconfig chassis remoteaccess config=nic enableipmi=true

And this will enable IPMI Over Lan.

On a side note, if you receive this error:

Error: Unable to establish LAN session
Error: Unable to establish IPMI v1.5 / RMCP session

Then make sure you are using IPMI v2 Lanplus (the `-I lanplus` option in ipmitool) so that your IPMI software is communicating using the right protocol.

  • 1 Utenti hanno trovato utile questa risposta
Hai trovato utile questa risposta?

Articoli Correlati

How to Install Dell EMC OpenManage Server Administrator (Linux)

Repository setup To configure the repository, use the following commands: curl -O...

How to install Dell System Update (CentOS/RHEL)

Dell EMC System Update (DSU) is a script optimized update and deployment tool for applying Dell...

Powered by WHMCompleteSolution